ok first off im starting a project right now for my finepix A350 ( i know old , and not so great of a camera) well this is just a start but if all goes well i will be making a housing for another camera, this is just a test run… Well i have majority of it down but have one problem BUTTONS. Any ideas of how i can make buttons or buy button for an underwater housing. Also open to any cleaver ideas i know a couple but dont know how im going to get them to work, so im basically stuck. Thankz for all the help

Hi Emopants 92
You could try Ikelite USA, they have buttons as a spare part. I bought some years ago from them, to use in a housing I made.

Hi Emo

Depending on your abilities, it could not be so hard to design buttons yourselvf ? - I made a complete videohousing for a Canon once with all controlls. Try to lokk at the principle in the cheap off the shelf housings for compacts - they are normally just a spring loaded 2 mm stainless steel shaft passing trhough a couple of o-rings. You will of course need to do some experiments, so you get the dimensions right: Keeping it water tight, but still loos enoght to operate

Regards Flemming